Pellon Fusible Interfacing Products for Apparel and Crafts

* Pellon nonwoven interfacings are for wovens and knits.
* There is no preshrinking required.
* ALWAYS PRE-TEST on a scrap of fabric; fusing is not recommended for triacetate, lace, seersucker or r

General Directions

1. Trim and Steam Baste - Pin pattern piece to interfacing following grainline arrows; cut. Trim seam allowances to ¼” (6mm). Next place fusible side of Pellon on wrong side of fabric. Pin, then steam baste along edges with tip of iron. Remove pins.

2. Fuse - Cover with a DAMP press cloth. Set iron setting to correspond with the fusible being used:

* 911FF for Midweight fabrics—set iron on medium/steam setting. Press firmly for full 10 seconds.

Repeat, lifting and slightly overlapping iron until all interfacing is fused. Steam press on right side. Let fabric cool, then check bond. Use steam iron with metal sole plate. Hand-held steamers will not permanently bond interfacing to fabric.

Tip:

* Use your damp press cloth as a temperature and timing guide. After 10-15 seconds, press cloth should be dry. If not, raise iron temperature or hold iron in place a few seconds longer.

Care Instructions:

* Washable, dry cleanable
* Machine wash Warm, machine dry Low, iron Medium Perma-Press